Assembly Instructions – The Munchkin. What you will need:
  • 1 power-drill, either electric or cordless
    • Phillips Head drill tip
    • 8m Hex Head drill tip
 Hardware included:
  • Hex Head Screws – used for:
    • Joining walls to walls and to floor sections
    • Securing roof
    • Fixing posts and pickets
  • Phillip Head Screws – used for:
    • Attaching the corner trim pieces.
 Cubby Sections included:
  • Cubby:
    • Cubby Floor
    • Front wall, back wall, external side wall (left side) and internal side wall (right side)
    • 2 roof sections
    • 2 pickets
    • 2 verandah posts
    • 4 corner trims (shorter ones belong on the front)
  To Construct: Attach walls to floor:
  • Place cubby floor in position – ensure floor is level.
  • Stand the back gable wall and one side wall on the floor.  The wall frame should sit flush on top of the floor.
  • Use the Hex Head screws to attach the walls to each other.  Do not screw the walls to the floor.  This stage will come later.
    • attach approx 10cm from the top and bottom of the frame using the Hex Head Screws
  • Follow the last two steps for each of the wall sections.
  • Attach all walls to the floor ensuring you screw into the floor bearers where possible (bearers are the beams running underneath the floor).
   Attach Roof:
  • Place the one roof section (with timber trim and no capping) onto one side of the cubby.  The timber trim is the bottom edge.  Ensure that the angle cut at the top is aligned with the apex of the cubby.
    • From inside the cubby use a Hex Head screw to screw up through the side wall frame and into the roof batten.
  • Position the other roof section, the capping should sit over the top (remove the clear plastic from capping first).  The angle cut of side timber should meet at the apex.
    • From inside screw up from frame into battens.
 Verandah and Pickets:
  • Hold one picket against the side of the cubby and along the verandah floor.  Leave approx 8-10cm clearance up from floor and attach to cubby wall (from inside of picket frame) and screw into the wall frame.
  • Butt a verandah post against the picket and attach from the inside of the picket frame.
    • On a diagonal, screw the verandah post into the verandah floor using the pre-drilled holes.
  • Repeat this step for the other side.
 Lastly:·         Attach corner stops to each corner of the cubby with Phillip head screws. Congratulations:  Thank you from the Design A Shed team.